![]() ![]() Step 3: Then, you must press the mount tightly and push the locking lever up. Dash is a Python framework for building ML & data science web apps. Step 2 : After that place the mount in the center of the windshield. In this video, learn how to install the Dash library. You can pull any large excess cable through by the airbag.Ģ1) Wait on Amazon to deliver your mirror mount for your dash cam. Step 1 : For the dashcam installation, you need to peel off the protective film of the windshield mount. You may not have this, depending on your trim level.ġ6) Once you have your USB routed, use your fingers and your panel tool to push the excess wiring into your headliner at the top of your windshield. In this tutorial, you used the IBM Cloud App ID service to add authentication and authorization to a Python web application that uses the Dash framework. It was still a very tight fit.ġ5) Take the USB end of your hardwire kit and route it through your mirror assembly. Also, install the dash dependency in addition to flask and requests with the following command: pip3 install dash Show more. I had to poke my finger in there to push the air bag down, then used my panel tool to give myself space to work. Installing dash and its dependencies is as simple as install. Do not remove it all, leave the back and the bottom in place.ġ4) Pop the top of your A pillar trim, and then and then take the end of your hardwire kit, and carefully route it over the side curtain air bag. My kit had a small box where the wire switched over to the USB - I zip tied this to one of the existing harnesses.ġ3) Remove the front rubber door trim/weatherstripping. Zip tie your cabling on this side to be secure as well. Leave extra on the side of the cigarette lighter so you have slack to remove that part of the dash later for another project, and tie wrap your wiring to keep it secure.ġ2) Routed your wiring to the carpet, and then under to the space behind the kick panel. No picture for this one.ġ1) Route your wiring to avoid the knee air bag, and the space where the glove box will go. Mounting: Attach the dash cam to your windshield or dashboard using the. I had to stick my head up into the hole where the glove box was to get it mostly lined up, then plugged it in by feel. In general, the installation process for most dash cams involves a few common steps: 1. The hardwire kit will poke out after the second zip tie.ġ0) Plug the harness back into the cigarette lighter. Once you have wrapped both wires independently in tape, place a small zip tie on each wire just behind the join, and then a small zip tie on all the wires.ĩ) Zip tie the fabric wrap back around your wiring. 7) Take the end of your hardwire kit and feed the corresponding wire through the middle of the hole you poked in the existing harness then twist the copper around the exposed wiring on the harness.Ĩ) Cut a few inches of electrical tape and tightly wrap each connection, while laying the hardwire kit wiring flat along the existing harness. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |